King Electric Model PSH2440TB - Manual (Page 3)

the wood stud in wall or joist in ceiling.
2. Use holes in bracket to mark 3 holes for drilling.
drill 3 holes for screws. Be sure holes are drilled into
7. Insert the third 66 mm screw with a washer through the mid
hole on bracket, tighten screw against bracket to secure.
3
SAVE THESE INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
KING ELECTRIC MFG CO · 9131 10TH AVENUE SOUTH · SEATTLE, WA 98108 · PH:206 762 0400 · FAX: 206 763 7738 · www.king-electric.com
PSH2440TB
Portable Shop Heater
TOOLS NEEDED:
- Power Drill
- 4 mm or 5/32 in. drill bit
- Phillips head screwdriver
- Stud finder
Remove heater & all packaging materials from the box.
Tip: Be sure to remove the hardware package from the
Styrofoam packaging.
Attaching Heater to Wall Bracket
1. Line up hole on bracket with hole on the heater handle.
2. Attach heater to bracket with 20mm screw and nut, larger
10 mm washer and locking washer.
Be certain adjustment knobs are tightened
firmly to secure heater to swivel bracket.
Wall or Ceiling Mounting
1. Locate wood stud in wall or joist in ceiling to mount heater.
3. Pre-
4. Secure two 66 mm screws to wall leaving 1/8” exposed.
Two (2)
screws must be attached to a wood stud (min 1.5”).
5. Attached bracket to wall by inserting screws through
keyholes on bracket and pushing down to lock in place.
6. Tighten screws against bracket to secure.
HEATER MUST BE ATTACHED TO A JOIST
WITH A MINIMUM OF TWO (2) SCREWS IN
OPPOSING HOLES.
Use appropriate fasteners. The screws
included are for installing in wood studs only
and not intended for metal joists.
INSTALLATION INSTRUCTIONS
! WARNING
! WARNING
! WARNING
FOR WALL OR CEILING MOUNT APPLCATIONS
FOR WALL MOUNT APPLCATIONS FOR CEILING MOUNT APPLCATIONS
1
2
3
1
2
3
8.5"
1"
8.5"
1"