Autonet Routan K6860899 - Manual (Page 2)

2
6. Secure the Wi­Fi router bracket (1) under the passen­
ger seat with the provided materials.
7. Connect the power harness connector (2) to the Wi­Fi
router.
NOTE: Do not use the power outlet for the power supply to the Wi­Fi router.
8. Locate the cigarette lighter outlet wiring harness.
9. Cut each wire and remove 13 mm (0.5 in.) of insula­
tion from each wire that needs to be soldered/spliced.
10. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol­
dered area.
CAUTION: Do not use acid core solder.
11. Solder the supplied fused pigtail to Wi­Fi power har­
ness power wire.
12. Place the strands of the power side wires overlapping
each other inside of the splice clip (1).
Oct 16, 2009 K6860899 Rev.
2