King Electric TCM - Manual

TC / TCM Thermal Storage
Cable and Mats Systems
DANGER ! !
ELECTRIC SHOCK OR FIRE HAZARD
READ ALL WIRE SIZING, VOLTAGE REQUIREMENTS AND SAFETY DATA TO
AVOID PROPERTY DAMAGE AND PERSONAL INJURY
WARNING ! !
KING ELECTRIC
READ CAREFULLY - I t is important to read these instructions carefully before installing the TC Thermal Storage System. Installation must be
performed by qualified personnel, in accordance with local codes and standards.
Read these important warnings and all installation instructions prior to installation. Failure to do so can result in fire, electrical shock, property
TC / TCM is a heating system usually intended to be the sole source of heat in the building.
King strongly recommends consulting with a building engineer, architect or qualified professional to ensure that the TC ther-
mal storage system selected will be suitable for your intended application.
The installation shall be in accordance with the manufacturer's instructions and national and local electrical codes. The instal-
lation shall be in accordance with Part 426, American National Standard Institute / National Fire Protection Association (ANSI/
NFPA70), National Electrical Code (NEC) and Canadian Electrical Code (CEC), Part 1. You must use a ground fault protection
device (GFCI) or a Residual Current Device (RCD).
All local codes concerning buildings, electrical installations etc. must be adhered to regardless of instructions provided in this
manual. If these regulations are in direct conflict with instructions stated herein, please contact the manufacturer.
It is important that this equipment is only installed by qualified electricians who are familiar with the proper sizing, installation,
construction and operation of electric heating cable systems and the hazards involved. The TC system is only designed for
installation in concrete or sand applications.
Metal structures or materials used for the support of or on which the Jiahong TC is installed must be grounded in accordance-
with CSA Standard C22.1, Section 10 and the NEC.
! WARNING
! WARNING
! WARNING
! WARNING
! WARNING
! WARNING
King’s Thermal Storage Heating systems are designed to warm the concrete slab of a building, creating a heated thermal mass below the floor
surface that radiates heat into the building throughout the day. Perfect for a both commercial and residential heating applications, heating
floors in an efficient manner. King’s system runs during off peak hours, heating the floor to a comfortable and consistent temperature, and then
shuts off during peak hours using the stored heat to keep costs down.
TCM Series Mats offers the easiest solution to in-concrete thermal storage, providing pre-fabricated mats at 12W/SqFt (6” spacing) that can
be rolled out prior to the concrete slab being poured.
TC Series Cable offers a custom layout solution to in-concrete thermal storage, that can be installed to fit any individual application. Cable can
be spaced to allow between 12W/SqFt – 17W/SqFt (4”, 5” or 6” spacing) depending on the application.
SAVE THESE INSTRUCTIONS
SAFTEY INFORMATION