LA STEELCRAFT AB-30P5 - Manual (Page 2)

2 7/8" OD
FRONT ARCH
2 3/8" OD
HORIZONTAL BRACE
SLEEVE FITTING
SET SCREW
HORIZONTAL BRACE CONNECTION
PARTS
INSTRUCTIONS
DATE: 9/5/09 DRAWN BY: AFS
DO NOT SCALE DRAWING
STEELCRAFT PRODUCTS
P.O. Box 90365 - Pasadena, CA 91109
PHN 626-798-7401 FAX 626-798-1482
MODEL
DO NOT SCALE DRAWING
AB-30P5
EXTENSION DETAILS
NOTE: SPECIFICATIONS ARE SUBJECT TO CHANGE
1. INSTALL FRONT ARCH SIMILAR TO FRONT ARCH OF THE BASE BACKSTOP. THE EXTENSION
ARCH IS TO BE 5’-4 ½” IN FRONT OF THE BASE BACKSTOP.
2. INSERT THE TOP FRONT BRACE IN THE STUB ON THE FRONT BASE ARCH AND THE
EXTENSION ARCH. TIGHTEN THE SET SCREWS.
3. THE EXTENSION BRACES ARE TO BE SPACED AT APPROXIMATELY 5’-6” C-C. PLACE A
BRACE BAND AT THIS SPACING TO RECEIVE THE EIGHT REMAINING FRONT BRACES.
4. PLACE THE SLIP FITTING IN EACH END OF THE FRONT BRACE AND ATTACH TO THE BRACE
BANDS USING HARDWARE PROVIDED. ADJUST TO MAKE THE FRONT ARCH
PERPENDICULAR AND TIGHTEN SET SCREWS.
5. PLACE TENSION BANDS AT APPROXIMATELY 5’-0” SPACING. PLACE THE CHAIN LINK
FABRIC ON THE TOP OF THE EXTENSION AND ATTACH TO THE TENSION BARS/BANDS.
ITEM QUANT DESCRIPTION
A 1 CENTER FRONT TOP SECTION: 2-7/8" od GALV PIPE X w/
INTERNAL FITTINGS ON EACH END AND 1 STUB FITTINGS
WELDED AT CENTER TO RECEIVE THE CENTER VERTICAL
RIB.
B 2 LEFT AND RIGHT SIDE FRONT ARCH TOP SECTIONS MADE
OF 2-7/8" OD GALV. PIPE. BOTTOM END EXTENDS INTO
FOOTING
C 2 LEFT AND RIGHT SIDE FRONT ARCH TOP SECTIONS MADE
OF 2-7/8" OD GALV. PIPE. BOTTOM END EXTENDS INTO
FOOTING
D 17 HORIZONTAL STIFFENERS (BRACES): 2-3/8" OD @ 4'-9"
GALV. PIPE.
E 42 2-7/8" TENSION BANDS
F 80 2" - 9 ga. X 5 ft. WIDE CHAIN LINK FABRIC
G 80 5/16" X 1-1/4" CC BOLT w/ LOCK NUT
H 18 10 ft. TENSION BARS