Advent UBTSW2 - Manual (Page 3)

3
UBTSW2 Installation Instructions
Determine and Inspect Location
Drill Hole
Find an appropriate location that does not interfere with the safe operation of the vehicle. Inspect the location
from the front and rear to confirm that no wiring, accessories, etc. are located beneath the proposed mounting
surface. Also ensure that there is a minimum or 3 inches depth behind the dashboard.
Using a 1” hole saw or drill bit, drill the installation hole in the dashboard.
UBTSW2 SWITCH INPUT
NO FUNCTION
BTHFMOD
Install UBTSW2
Route wire from the UBTSW2 and plug into the BTHFMOD, as illustrated below.
Install Microphone
1. Determine a good mounting location for the microphone. The following locations are recommended:
Ÿ top of the driver's A pillar
Ÿ steering column
2. Place the Microphone in the intended mounting location.
3. Test the system to ensure good sound quality.
4. If the location is suitable, use the supplied double-sided tape to mount the base of the microphone.
5. Carefully run the cable to the MIC input on the control unit.