LEDGlow Advanced Single Color Flexible Motorcycle Light Kit User Manual
Page 2
sure to use the zip ties, this is a very important step and should not be skipped. Once this step is complete and the
lighting strips and wires are secure, allow ample time for the adhesive to settle and cure. Repeat this step for the
remaining strips included with your kit
7.
Find a secure and dry place to mount the control box. We recommend mounting it under the seat or in a water tight
compartment if possible. If this is not possible then we suggest mounting the control box in the driest place available.
The control box is not designed to withstand any water damage and if any does occur, it will void all warranties.
Optional: Seal the end caps of the control box with silicone to prevent water damage.
8.
Connect the red power wire from the control box to the positive terminal of the battery. If the power wire needs to be
extended, be sure to use 16 or 18 gauge automotive grade wire. Be sure to reinstall the fuse within 6 inches of the
battery. Connect the black ground wire to the negative terminal of the battery.
9.
The kit was designed using a modular locking system for connecting the motorcycle lighting strips to the control box
by using the included wire harness. Start plugging the male connections from the strips and control box into the female
connections of the harness. Secure the excess wires of the strips and wire harness to the frame of your bike by using the
included zip ties. DO NOT SHORTEN OR CUT ANY WIRES, YOU WILL VOID THE WARRANTY.
10. If you removed any trim for this installation, you can now reinstall them and test the functionality of your kit by
pressing the on/off button on the wireless remote.
11. For more information, please refer to our instructional videos that can be found a
Wireless Remote Functions
This kit provides several brightness and multiple patterns, which are easily operated using the included wireless remote.
The remote includes four buttons “A, B, C, D”:
Button A: Powers the kit on and controls 4 levels of brightness.
Button B: Provides several strobing and flashing modes
Button C: Color Fade Mode
Button D: Turns the Kit Off
Reprogramming the Wireless Remote:
Remove the end cap from the control box and slide the circuit board out of the housing. Remove the tape from around
the circuit board. Once the tape is removed, you will see a white box on the circuit board that says “key”. Using a paper clip,
touch the two silver tabs that are located at the bottom of the “key” box. Once you touch the two silver tabs, a red LED will
illuminate. While the LED is lit, press any button on the wireless remote and you will see the LED flash and turn off. Press the
“A” button on the remote to power the kit and ensure it is functioning properly. Place the tape back on the circuit board and slide
it back into the housing of the control box.
Troubleshooting:
If the kit or lights do not appear to operate, first check the installed inline mini fuse. If the fuse is blown, check the
wires on the entire kit to ensure they are not cut, pinched or scorched. If there is no damage to any of the wires and no water
damage is visible to the control box, replace the fuse and test the kit again. If the inline fuse is intact, clean both the positive and
negative terminals of the battery. Corrosion to the battery terminal can cause a poor connection or simulate being disconnected.
For accessories, add-on kits, replacement parts, and/or technical support, please visit
or more information.