LEDGlow Flexible Million Color Motorcycle Lighting Kit User Manual
Page 2
complete and the lighting tubes and wires are secure, allow ample time for the adhesive to settle and cure. Repeat this
step for the remaining tubes included with your kit.
7.
Find a secure and dry place to mount the control box. We recommend mounting it under the seat or in a water tight
compartment if possible. If this is not possible then we suggest mounting the control box in the driest place available.
The control box is not designed to withstand any water damage and if any does occur, it will void all warranties.
8.
Connect the red power wire from the control box to the positive terminal of the battery. If the power wire needs to be
extended, be sure to use 16 or 18 gauge automotive grade wire. Be sure to reinstall a fuse within 6 inches of the battery.
Connect the black ground wire to the negative terminal of the battery.
9.
Connect the male connections of the wires from the lighting tubes to the female ports of the control box. Secure the
excess wires of the tubes to the frame of your bike by using zip ties. DO NOT CUT OR SHORTEN ANY WIRES,
YOU WILL VOID THE WARRANTY.
10. If you removed any trim for this installation, you can now reinstall them and test the functionality of your kit by
pressing the on/off button on the wireless remote.
11. For more information, please refer to our instructional videos that can be found a
Wireless Remote Functions:
This kit provides multiple colors, lighting patterns and several speed levels, which are easily operated using the
included wireless remote. The remote includes four buttons, “A, B, C, D”
Button A: Controls Color and Pattern Selections
Button B: Turns the Kit On/Off
Button C: Speed Up Lighting Pattern
Button D: Slows Down Lighting Pattern
Reprogramming the Wireless Remote:
To reprogram the wireless remote, you will simultaneously press and hold the button that’s located on top of the control
box as well as the “B” button on the wireless remote for 3-5 seconds. If the reprogramming was successful, your lighting kit will
flash the color green.
Troubleshooting:
If the kit or lights do not appear to operate, first check the installed inline mini fuse. If the fuse is blown, check the
wires on the entire kit to ensure they are not cut, pinched or scorched. If there is no damage to any of the wires and no water
damage is visible to the control box, replace the fuse and test the kit again. If the inline fuse is intact, clean both the positive and
negative terminals of the battery. Corrosion to the battery terminal can cause a poor connection or simulate being disconnected.
For accessories, replacement parts and/or technical support, please visit
for more information.