LEDGlow Single Color SMD Pod Motorcycle Lighting Kit User Manual
Page 2
6.
Mount each pod light to the cleaned and dry surface of the motorcycle by using the supplied 3M tape under the
pod light. Run the wires to the planned location of the power switch or control box and secure the wire to the bike
frame by using zip ties. Once this step is complete and the pod lights and wires are secure, allow ample time for
the adhesive to settle and cure. Repeat this step for the remaining pod lights included with your kit.
7.
Find a secure and dry location to mount the power switch or control box. We recommend mounting it under the
seat or in a water tight compartment if possible. If this is not possible then we suggest mounting it in the driest
location available. The power switch and/or control box is not designed to withstand any water damage and
if any does occur, it will void all warranties. Optional: Seal the end caps of the control box with silicone to
prevent water damage.
8.
Power Switch Installation: Connect the white stripe power wire from the power switch to the positive terminal of
the battery. Connect the black ground wire to the negative terminal of the battery.
9.
Control Box Installation: Connect the red power wire from the control box to the positive terminal of the battery.
Connect the black ground wire to the negative terminal of the battery.
10. The pod lighting kit was designed using a modular locking plug system for connecting the motorcycle pod lights
to the power switch or control box by using the included wire harness. Start plugging the male connections from
the pod lights and power switch/control box into the female connections of the harness. Secure the excess wires of
the pod lights and harness to the frame of your bike by using zip ties. DO NOT CUT OR SHORTEN ANY
WIRES, YOU WILL VOID THE WARRANTY.
11. If you removed any trim for this installation, you can now reinstall them and test the functionality of your kit by
pressing the power switch or button “A” on the wireless remote.
12. Expandability: This Pod Lighting Kit has the ability to be expanded to include up to 20 pod lights for maximum
brightness. Users can purchase Add-On Pod Lights directly from
13. For more information, please refer to our instructional videos that can be found a
Wireless Remote Functions:
This kit provides multiple lighting patterns and several brightness levels, which are easily operated by using the
included wireless remote. The remote includes four buttons, “A, B, C, D”
Button A: Powers the Kit On and Controls 4 Brightness Levels
Button B: Controls 3 Strobing Modes
Button C: Controls Fading Mode
Button D: Turns the Kit Off
Reprogramming the Wireless Remote:
Remove the end cap from the control box and slide the circuit board out of the housing. Remove the tape from around
the circuit board. Once the tape is removed, you will see a white box on the circuit board that says “key”. Using a paper clip,
touch the two silver tabs that are located at the bottom of the “key” box. Once you touch the two silver tabs, a red LED will
illuminate. While the LED is lit, press any button on the wireless remote and you will see the LED flash and turn off. Press the
“A” button the remote to power the kit and ensure it is functioning properly. Place the tape back on the circuit board and slide it
back into the housing of the control box.
Troubleshooting:
If the kit or lights do not appear to operate, first check the installed inline mini fuse. If the fuse is blown, check the
wires on the entire kit to ensure they are not cut, pinched or scorched. If there is no damage to any of the wires and no water
damage is visible to the control box, replace the fuse and test the kit again. If the inline fuse is intact, clean both the positive and
negative terminals of the battery. Corrosion to the battery terminal can cause a poor connection or simulate being disconnected.