Agilent Technologies E6474A - Manual (Page 2)

2
The purpose of this configuration guide is to assist you in ordering the correct system
configuration for your application.
The Agilent E6474A wireless network optimization platform is used to obtain RF coverage
measurements and service performance measurements for wireless communications
networks. The Windows
® based software runs on a PC that interfaces with an Agilent
digital RF receiver and with cdmaOne, cdma2000, HSDPA, UMTS, GSM, GPRS, EDGE,
and iDEN phones. The system can be configured to include receivers and phones from
one or a combination of technologies simultaneously. The system can control up to four
phones.
Recommended minimum
PC specifications:
The Agilent E6474A system requires a PC. The PC requirements differ depending on the
hardware configuration and on which parameters are being selected.
Minimum PC specifications:
• XP Professional SP2 (inc XP for Tablet PC)
• 1.6GHz Pentium M 512MB RAM
• Parallel port or USB Port (for software key)
• PCMCIA slot or a USB connection (for multiple hardware support)
• 30 GB hard disk space
• CD-ROM drive recommended for installation
• 1024 x 768 display resolution minimum
Recommended PC specifications:
• XP Professional SP2 (inc XP for Tablet PC)
• Intel® Core™ Duo T2500 (2GHz) 2GB RAM
• Parallel port or USB Port (for software key)
• PCMCIA slot or a USB connection (for multiple hardware support)
• 50 GB hard disk space
• CD-ROM drive recommended for installation
• 1280 x 1024 display resolution minimum
The Agilent network optimization drive test solution can be ordered through part numbers
E6473B, E6474A, W1314A, 86154A, 86156A, and E5643A. These part numbers are
described in this document.
Configuration Process Before using this configuration guide, the following decisions need to be made:
• Which technologies are required?
• Which software measurements are required?
• Which phones and receivers are required?
• Which accessories are required?