LevelOne WPC-0600 - Manual (Page 9)

N_One Wireless CardBus Adapter
Display 802.11g
Access Points Select this check box to display 802.11g (infrastructure) net-
works.
Network Name Available wireless networks are listed.
MAC Address This is the MAC address of the Access Point (or Wireless
station, if the network is an Ad-hoc network).
Security Data encryption and authentication methods used on the
wireless network
CH. The channel used by the Wireless network.
Signal This is displayed as percentage (0 ~ 100%).
Frequency The Wireless band used by this Wireless network.
Network Type This will indicate "Infrastructure" (displayed device is an Access
Point) or "Ad-hoc". (displayed device is a Wireless station)
Status The area to the left of the "Rescan" button shows the current
status. In the example above, it shows "Connected".
Rescan Click this button to rescan for all Wireless networks.
Wireless Network Sequence (order)
You can click the headings (ex. Network Name, MAC Address, Security…) of the
Wireless network table to arrange the Wireless network in the desired order.
To Connect to a Wireless Network
• Double-click on the desired network.
• Click the name of the wireless network to which you want to connect, and then
click Connect.
Note that once you are connected to a Wireless network, the Site Survey screen will
identify the current wireless network with a blue icon, as shown below.
Figure 8: Site Survey Screen - Connected
7