AOpen DX34 PLUS - Manual (Page 2)

1. Installing CPU
2. Installing CPU & Housing Fan
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
Online
User's Manual can be found in the
Bonus Pack CD Disc . Thanks for
the help of saving our earth!
PART NO: 90.50F30.002 DOC. NO: DX34-EG-E0104C
Ø Hard Drive IDE Cable x 1
Ø Driver CD x 1
Ø Norton Anti-Virus CD x1
Ø ASM Lite CD x 1
Ø IO Bracket for SV320 x 1
Ø IO Bracket for Open Market Housing x 1
Ø SCSI Utility Diskette Pack x 1 (DX34 Plus)
Ø Ultra 160 SCSI 68 pin Cable x 1 (DX34 Plus)
Ø CD In Cable x 1 (DX34)
Ø Screw Pack x 1
Ø User Manual x 1
Ø This Easy Installation Guide x 1
Plug in the CPU fan cable to the CPU FAN connector and housing fan cable to the Housing Fan
connector. For DX34 Plus, we provide two configurations of system fan connector for better compatibility
with different housing. Please do take care of the type of connector on your motherboard.
1. Pull up the CPU socket level and up to
90-degree angle.
2. Locate Pin 1 in the socket and look for a
(golden) cut edge on the CPU upper interface.
Match Pin 1 and cut edge. Then insert the
CPU into the socket.
3. Press down the CPU socket level and finish
CPU installation.
Note: If you do not match the CPU
socket Pin 1 and CPU cut edge well,
it may damage the CPU.
CPU Pin 1 and cut edge
CPU socket lever
GND
+12V
Sensor
CPU fan
connector
System fan
connector
+12V
Fan Off (GND)
Fan Fail
Sensor
GND
+12V
Sensor
Two configuration system fan
connector for DX34 Plus