LiftMaster CSL24V High-Cycle Commercial Slide Gate Operator with Battery Backup - Manual

QuickStart
for single gate applications
This QuickStart is intended to highlight a single right-hand gate application. Each application is unique and it is the responsibility of the purchaser, installer and end user to ensure that the
total gate system is installed and operated properly. Refer to the installation manual for complete information regarding installation, testing, and programming.
MODEL CSL24V ™ & CSL24VH ™
1
Install the concrete pad and conduit.
2
Attach the operator to the concrete pad.
3
Attach the gate brackets to the gate.
4
Close the gate.
5
Route the chain through the operator.
6
Connect the chain to the gate brackets.
7
Remove the pin from the vent plug on the gear box.
1
2
5
6
6
3
Close the gate BEFORE installing the chain.
4
3
7
INSTALLATION
INSTALL THE COVER
1
Align the tabs on the rear cover with the slots on the chassis
and place the cover over the operator.
2
Secure both sides of the rear cover to the chassis with two
5/16-18 hex bolts and washers.
3
Align the front cover with the back cover, making sure the
grooves line up.
4
Secure the front cover to the chassis with two 5/16-18 hex
bolts and washers.
5
Secure the front cover to the rear cover using the 5/16-18
screw.
Tabs on Rear Cover
Slots on Chassis
Groove on Front Cover
5/16-18
Hex Bolts
and Washers
5/16-18
Screw