Luxor|H.Wilson OHS42 - Manual

Instruction Sheet
Endura Overhead Projector Tables
Models OHT42, OHT42PS, and OHS42
Customer Service Dept
2245 Delany Rd • Waukegan, IL 60087
Ph: 847/244-1800 • 800/323-4656
Fax: 847/244-1818 • 800/327-1698
OHT42
1 - Top shelf w/handle
1 - Middle shelf w/8 leg posts
1 - Bottom shelf w/caster sockets
1 - Set short legs
1 - Set long legs
4 - Casters (2 w/brake)
1 - Electric assembly
Tools Required:
Rubber mallet
OHS42
1 - Top shelf w/utility tray
1 - Middle shelf w/8 leg posts
1 - Bottom shelf w/caster sockets
1 - Set short legs
1 - Set long legs
4 - Casters (2 w/brake)
1 - Electric assembly
Parts List
Model OHT42 Model OHT42 Model OHS42 Both Models
Both Models Both Models Both Models
OHS42 OHT42PS OHT42
If your Endura Overhead Projector
Table does not have the Electrical
Assembly and Cable-Track TM Cord
Management System, start by
closing the electric plug housing
in the handle of the top shelf as
illustrated.
1.
Install grommet ring by tapping into place with rubber
mallet. Insert grommet cap as illustrated. For tables
with electric assembly, snap off cord guide cover from
grommet cap so equipment plug may be run through
grommet plug unit, then insert grommet cap into
grommet ring.
2.
Lay top shelf (with handle) ribbed side up on a smooth
surface. Push all 4 short legs onto leg posts.
3.
Lay top utility shelf (with handle) ribbed side up on a
smooth surface. Push all 4 short legs onto leg posts.
4.
Position second shelf (with 8 leg posts) ribbed side up,
over the 4 legs and insert leg posts into legs. Using a
rubber mallet, firmly hammer bottom shelf into legs
until all four legs are seated (flush) against the surfaces
of both shelves.
5.
Push set of 4 long legs into leg posts of second shelf
and firmly hammer until properly seated.
6.
Position bottom shelf, ribbed side up, over the 4 long legs
and insert leg posts into legs. Using a rubber mallet, firmly
hammer bottom shelf into legs until all four legs are seated
(flush) against the surfaces of both shelves.
7.
Push the four casters firmly into the holes in each
corner of the bottom shelf. Important: casters must be
fully seated. Tap firmly with rubber mallet to properly
seat casters. Turn your table right side up. It is now
ready for use.
PLUG
HOUSING
COVER
FRONT
BACK
PLACE LOCKING CASTERS
AS ILLUSTRATED
1. The electric unit should be
assembled first. Cord wrap must be
installed on leg before assembly of
complete unit. See below.
2.Secure power cord plug
management ties into starter holes
with sheet metal screws.
3. Firmly seat electric assembly 3 plug
unit into handle plug housing as
illustrated. Secure with power cord plug
retaining bracket.
Illustration A OHT42/OHS42 ONLY
CABLE GROMMET HOLE
CORD
MANAGEMENT
TIE
3 PLUG UNIT
POWER CORD PLUG
RETAINING BRACKET
CORD RETAINING TRACK
3 PLUG UNIT
PLUG HOUSING