Luxor|H.Wilson WGB4836 User Manual

Horizontal orientation vertical orientation

Advertising
background image

12/17/13

Wall-mounted Glass Board

Instructions

WARNING: Two people are required to

build this Glass Board. Use care when

handling the Glass Board.

Snap two horizontal chalk

lines at the shown height.

Drill four holes as shown

(Stud is recommended). If

there is no stud Hammer

drywall anchors B into holes.

Secure Pucks A at the

bottom like shown with

screw C make sure the

positioning is level and the

notch is facing up, leave

the clamp facing down.

Secure Pucks A at the top

with screw C make sure

the positioning is level and

the notch is facing down,

Secure the clamp with

wrench E so the clamp is

locked, facing up.

Semi-tighten the Puck clamps

A in the up position and place

the silicone inserts D into the

notches. Carefully lift the glass

board so that it rests on top of

the inserts, seated fully into the

notches, then tighten the clamps.

Wedge the silicone inserts

D into the open notch A.

Carefully push the glass

board into the open notch

and fold the silicone over the

glass and tighten the clamps

fully. Assembly Complete!

1

2

3

4

5

Parts List

- Tape Measure

- Chalk Line

- Drill

- 1/4˝ Drill Bit (No Stud)

- 1/8˝ Drill Bit (Stud)

- Extended Drive Phillips

- Hammer

- Level

- Stud Finder

- Pencil

A x4

B x4

C x4

D x4

E x4

Tools Required

Note: Hardware provided is for drywall installation. If attaching

to other material fasteners are to be furnished by other.

Chalk Line desired

bottom position.

Recommended

37

1

4

˝ from floor.

Chalk Line

35

7

16

˝ above the

bottom Chalk

Line

Chalk Line desired

bottom position.

Recommended

31

3

8

˝ from floor.

Chalk Line

47

7

16

˝ above the

bottom Chalk

Line

6

13

16

˝

4

13

16

˝

4

13

16

˝

4

13

16

˝

4

13

16

˝

6

13

16

˝

6

13

16

˝

6

13

16

˝

26˝

26˝

35˝

35˝

Hole Locations

Hole Locations

35

5

8

˝ x 48

5

8

˝ Board

48

5

8

˝

48

5

8

˝

36

5

8

˝

36

5

8

˝

Hole Locations

Hole Locations

Horizontal Orientation

Vertical Orientation

STUD

NO STUD

DRYWALL

RECOMMENDED:

1/8˝ Bit

1/4˝ Bit

DRYWALL

Assembly

Requires Two

People

Perform the

steps detailed in

unison, having a

person on each

side tighten

adjacent pucks

at the same time.

B

A

A

C

C

E

1.

3.

2.

4.

E

E

A

A

A

A

D

D

D

Advertising