Luxor|H.Wilson WPSDD3 - Manual (Page 3)

04/05/13
Detach lock E
faceplate prior
to installation
Cam may come preinstalled. If not
loosen drawer runner to install cam.
NOTE: Keep drawer
runner loosened in order
to tighten cam locks
Make sure the
grommet P of
back panel 3 is
below divider 2
Screw 4 metal dowels A into drawer front 9a. Use
drill on lock E with 4 lock screws M onto drawer front
9a. Install 4 cams into drawer sides 9b & 9c. Screw
handle F onto the drawer front 9a with handle screw J.
Use drill on 2 side shelf brackets N into
side shelf 10 with 8 wood screws Ca.
Install the other side panel 4 or
5 onto the main unit. Tighten the
cams that cover the metal dowels.
With assistance, lift the unit so the
top is facing up. Install top panel
6a and tighten the 4 cams.
With assistance lift the unit so the
bottom is facing up. Install the
bottom panel 6b and tighten the 4
cams.
Place the top support brace 1 the horizontal divider 2
and the back panel 3 onto a side panel 4 or 5. Tighten
the 6 cams that cover the metal dowels. Insert the
grommet P into back panel 3.
Attach the drawer sides 9b & 9c to the drawer front
9a, and turn the cams to lock into place. Slide the
bottom panel 9e down the grooves and then use drill
on drawer back 9d with 2 drawer screws K
(through the upper holes of 9b & 9c).
Bx2
Bx2
Ax2
Cax4
Cax4
Cax4
Cax4
Mx4
Ax2
Jx2
F
K
K
P
N
N
N
N
E
3/5
9a
10
12 13 14
11
9b
9a
9b
9c
9c
9a
9b
9e
9d
10
10
3
2
1
4 or 5
4 or 5
6a
6b