Luxor|H.Wilson WPSMS20CH - Manual (Page 3)

Philips head screw
M5x35
Adjusting the display
D
c Attaching the display to the wall plate
C
Note:
This procedure will require two persons.
Note:
For demonstration purposes, the wall has been omitted from the above images.
Step 1: Lift the display
Lift the display onto the wall plate as shown(Fig.1.).
Step 2: Lock the display
Tighten the Philips head screw M5x35 until attach the wall plate as shown(Fig.2.).
Step 2
Step 1
Installation complete!
Now, you can enjoy your display!
Attach the display
B
Note:
Recessed Mounting Holes. If the mounting holes are
recessed into the back of the display, use the supplied
spacers to pack the recessed hole. Ensure that the
hook brackets are securely fixed to the display.
Fixed the hook bracket onto the display with
the selected mounting screws, square washers,
and any required spacers.
Tighten them using Philips head screw driver
Tilt -5
Tilt 15
Tilt Adjustment -Raising or lowering the screen
to improve viewing angle.
Grasp the upper and lower edges of the display,
and then turn it to the desired tilt angle(Fig.3.).
Fig.5.
Fig.1.
To lock the tilt angle, tighten the tilt knob(Fig.4.) securely.
Fig.2.
Fig.3.
D
B
C
A
Turn
Tighten
Fig.4.
Note: For heavier displays, never fully release the tilt knob
without fully supporting the display.
The tilt lever includes a ratchet function, so that it can be
lifted and repositioned for next turn. To operate the ratchet,
pull the lever and then turn it in the desired direction. Repeat
as necessary until the tilt tension is set properly(Fig.5.).
Mounting screws
Spacer
Metal washer
Ø6
Mounting
screws
Hook Bracket
2 / 2