Adcom GFR-700HD - Manual (Page 51)

51
Ch
ap
te
r 3 - S
et
up
www.adcom.com GFR-700HD Owner’s Manual
Deleting Remote Commands
Deleting a Command
1 On the GFR-700HD remote, press the applicable
Source and Select buttons simultaneously.
• The orange status LED and the Source button
glow and remain lit.
2 Press the button whose function you wish to
clear.
• The orange status LED begins flashing.
3 Press the Backlight button.
• The green status LED blinks twice and then
goes back to steady orange to indicate that
the command has been deleted.
• Repeat steps 2~3 for any other commands
you wish to delete for that Source compo-
nent.
4 Press the Source and Select buttons simultane-
ously to save and exit.
• The orange status LED blinks twice and turns
off.
Deleting all Commands for a Component
1 On the GFR-700HD remote, press the Source and
Select buttons simultaneously.
• The orange status LED and the Source button
glow and remain lit.
2 Press and hold the Backlight button.
• The red status LED blinks five times.
• The green status LED then blinks twice and
goes back to steady orange to indicate that
all commands for the selected Source com-
ponent have been deleted.
3 Press the Source and Select buttons simultane-
ously to save and exit.
• The status LED blinks twice and turns off.
Deleting all Commands for all Components
This procedure erases every programmed command
accessed under the selected Video 1, Video 2, Video
3, Video 4, CD, Tuner, and Room 2 input selectors.
Make sure you really want to do this before following
the step below.
1 Press and hold the Video 2 button and the Back-
light button simultaneously.
• The red status LED blinks twelve times.
• The status LED will then flash green once,
followed by a single orange pulse.
2 All LEDs will then turn off, indicating that every
learned command in the GFR-700HD remote has
been erased.
Backlight button