Southern Folger 4110L ELECTRIC LOCKING SYSTEMS - Manual (Page 2)

P.O. BOX 2021 • SAN ANTONIO, TX • 78297 • 210-533-1231 • FAX: 210-533-2211 Revised 7/12
L O C K I N G S Y S T E M S
FOR GROUPS OF
SLIDING CELL DOORS
Maximum security.
STANDARD FEATURES:
• Bottom door guide
• Door hanger
• Mechanical release cabinet
• Sloped-front cover box
• Hinged cover panel for maintenance access
• Vertical lock bar assembly
• ASTM F1643 Certified
Horizontal and Vertical Impact Test-Grade 1
• Prime paint finish
OPTIONAL FEATURES:
PILASTER RELEASE – (In lieu of mechanical release
cabinet.) Hip-high paracentric keyed mechanical release
mounted in a full-height pilaster adjacent to the receiving
jamb.
Specify “4110LP-1” keyed one side.
ELECTRIC KEYSWITCH – Paracentric or mogul keyed
local electric control switch mounted below mechanical
release mechanism in pilaster.
Specify “4110LPK-1” for paracentric keyed one side.
Specify “4110LPKM-1” for mogul keyed one side.
ELECTRIC HALF CYCLE – Door will not lock in any posi-
tion until it receives relock signal. This function requires the
use of a three position switch. Specify “D.”
HOT DIP GALVANIZED FINISH - Available for external
applications with lift-off cover panel only. Not available with
standard hinged cover panel. Specify “G” when ordering.
Example: 4110LP-1G
REMOTE PANEL LOCK SYSTEM - Remote panel option
is available with lift-off cover panel only. Not available with
standard hinged cover panel. Specify “RP” when ordering.
Example: 4110LRP
NO LOCK OPEN - Specify “NLO.”
Door does not lock in open position.
MOTOR – Specify “24 VDC.”
Inrush: 1.1A
Locked Rotor Current: 3.4A
FACTORY WIRED CONTROL CABLE
Specify “4110LWC.”
NOTE: Cover box minimum length =
(7" overtravel) + (2 x clear opening) + 9".
For doors exceeding 300 lbs. and/or greater
than 3’-2” clear opening, contact factory.
4110L ELECTRIC
LOCKING SYSTEM
4110L Shown
Note: Other system configurations and details are available.
Call Customer Service for more information.
B26
DETAIL B – VERTICAL LOCK JAMB BAR
4110L SLIDING DOOR SYSTEM
DETAIL D – BOTTOM DOOR GUIDE SECTION
DETAIL A – SLOPED BOX
DETAIL C – RECEIVER
COVER BOX SECTION
7-1/8" deep x 1' – 0-3/4" tall
cover box field welded 1" on 8"
top and bottom.
RECEIVER JAMB SECTION
Flush receiver jamb allows frame
opening and clear opening to
be the same.
090604SouthernFolger_final:INSIDE 8/21/09 5:22 PM Page 36