Staub Electronics EVC-100S-WHLA EPISODE - 100 W SLIDING VOLUME CONTROL - Manual (Page 5)

The spring-loaded mechanism will hold the wires in place.
3. Connect the wires going to each speaker to the connector labeled
SPEAKERS. Make sure to maintain proper polarity.
4. Check that the amplifier or receiver being used is turned off and
then connect the wire coming from the amplifier to the connector
labeled AMPLIFIER.
5. Once all conductors are inserted in to the connectors, visually
inspect each of your connections to ensure that there are no
stray strands that might short and that there is not an excessive
amount of exposed wire outside of the connector. Also be
sure that the connector is tightened down on bare wire and not
insulation. Install the connectors back on to the volume control
circuit board. Please be sure that the connectors are in the
correct place on the volume control.
REVERSING THE AMPLIFIER & SPEAKER CONNECTORS
WILL LIKELY CAUSE DAMAGE TO THE AMPLIFIER, VOLUME
CONTROL AND THE SPEAKERS AND IS NOT COVERED
UNDER WARRANTY.
6. An optional step is to change the color of the trim plate on
the face of the volume control. This is done easily by pressing
on the two tabs (only one tab for slider volume control) of the
plate on one end of the volume control and pushing towards
the knob shaft or slider lever. Rotate out the plate and replace
with the color of your choice.Your volume control is supplied
with white parts installed and almond parts included for an easy
and fast change. These are available for both the knob and
slider style volume controls. When the plate change is complete,
push the knob into place. When installing the slider plate, be
sure to align the slider knob with the slider mechanism.
5