Staub Electronics WB-400-IPCE-8 WATTBOX - IP CONTROLLABLE 8 OUTLET COMPACT POWER CONDITIONER WITH AUTO REBOOT - Manual (Page 3)

WB-400-IPCE-8 Installation and Users Manual
pg.3
© 2012 Wattbox ™
LED OPERATION
PROTECTED
AUTO REBOOT
SYSTEM STATUS
INTERNET
POWER
GROUNDED
WB-400-IPCE-8
TM
PROTECTED
AUTO REBOOT
SYSTEM STATUS
INTERNET
POWER
GROUNDED
PROTECTED
AUTO REBOOT
SYSTEM STATUS
INTERNET
POWER
GROUNDED
WB-400-IPCE-8
TM
PROTECTED
AUTO REBOOT
SYSTEM STATUS
INTERNET
POWER
GROUNDED
WB-400-IPCE-8
TM
PROTECTED
AUTO REBOOT
SYSTEM STATUS
INTERNET
POWER
GROUNDED
WB-400-IPCE-8
TM
Green (Solid): All sites/IP Addresses are communicating with the WattBox
Green (Flashing):
At least 1 (not all) Sites/IP Addresses are communicating with the
WattBox
Red (Solid): None of the Sites/IP Addresses are communicating with the WattBox.
When Illuminated:
Auto Reboot is Enabled, WattBox will perform power cycle for outlets that
are ON when communication with the assigned Website/IP Address is lost.
Note that outlets that are OFF, will not power cycle.
When Not
Illuminated:
Auto Reboot is Disabled, no power cycle will occur when communication
with the assigned Website/IP Address is lost.
Green (Solid): The WattBox is powered on and outlets are protected.
Off:
The WattBox is not powered on, or the MOVs have opened removing
power from the outlets.
Green (Solid):
WattBox processor is in an operating state and can be accessed via the
WattBox interface
Green (Flashing):
Firmware for the WattBox processor is being updated, during this state
the WattBox cannot be accessed via the WattBox interface.
Red (Solid):
WattBox processor is NOT in an operating state, reset button must be
pressed to return the WattBox to an operating state.
Green (Solid): Incoming AC outlet is grounded.
Off:
Incoming AC outlet is not grounded and requires inspection by an
electrician.