Autonet K6860631 - Manual (Page 2)

2
6. Secure the Wi-Fi Router under the passenger seat (1)
with the supplied tie straps and Velcro® tape (3).
7. Connect the power harness connector (2) to the Wi-Fi
router.
NOTE: Do not use the power outlet for the power supply to the Wi-Fi router.
8. Locate the keyed power outlet wiring harness.
9. Cut each wire and remove 13 mm (0.5 in.) of insula-
tion from each wire that needs to be soldered/spliced.
10. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
11. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
12. Place the strands of the power side wires overlapping
each other inside of the splice clip (1 ) along with the
red fuse holder wire(2).
March 24, 2009
K6860631 Rev. 1