Staub Electronics ES-SUB-WIRELESS EPISODE - WIRELESS SUBWOOFER KIT - Manual (Page 6)

PAIRING YOUR EPISODE
®
WIRELESS KIT
NOTE: Initial pairing may be performed without the audio signals connected. This may
be preferred for easier access to the pairing buttons and power connections. Follow the
instructions below to pair wireless transmitter and receiver.
1. Plug in the wireless transmitter. Transmitter’s LED will flash blue slowly.
2. Plug in the wireless receiver. Receiver’s LED will flash blue slowly.
3. Using a paperclip or other small tool, press and hold the “PAIR” button on
transmitter until its LED flashes quickly. Release button.
4. Press and hold the “PAIR” button on receiver until its LED flashes quickly.
Release button.
5. After a few seconds both LEDs will stop flashing and turn a solid blue, indicating
a permanent wireless link. Should you need to re-perform pairing for any reason,
simply repeat the process above.
NOTE: All wireless devices may be susceptible to RF interference from microwave ovens, cordless
phones, video game consoles, Wi-Fi networking hardware, Bluetooth ® headsets, baby monitors
and other devices. Specifically, any devices operating in the 2.4GHz band may cause intermittent
wireless connections between the transmitter and receiver in the EPISODE® wireless kit. Similarly,
your wireless kit may also affect other devices. The best method for reducing any potential
interference and maximizing wireless performance is to physically separate these devices by several
feet. If you notice the performance of your wireless kit being affected, check the proximity to other
wireless devices and relocate them accordingly. Any signal interference created by microwave ovens
or other appliances will subside when those devices are not in use.
RECEIVER TRANSMITTER
LED PAIR
Button
PAIR
Button
Status LED