Staub Electronics EA-AMP-12D-70A EPISODE - 12 CHANNEL 70 WATTS DIGITAL AMPLIFIER WITH AUTO POWER User Manual
Page 5
© 2011 Episode
pg.5
1. GLOBAL INPUT
Easily amplify outputs from any stereo source across any/all channels
2. LOOP OUT
Allows global inputs to be sent to other amplifiers
3. GAIN CONTROL
Allows independent gain for each pair of inputs
4. BRIDGED SWITCH
Easily couple two channels together for increased power
NOTE: 8-ohm minimum when using bridge mode
5. LINE INPUTS
Individual channel inputs for use with multi-channel preamps/ or dedicated sources
6. INPUT SWITCH
Choose between global inputs and individual inputs for each channel
7. SPEAKER OUTPUTS
8. MASTER POWER SWITCH
Disables power to the amplifier
7. POWER MODE SWITCH
Sets the amplifiers power mode:
On – Turns ON / OFF via front power button
12V – Turns on when +12V is received at Trigger input
AUDIO - Turns on when a minimal amount of audio signal is received at the audio
inputs and will go into standby after 18 minutes of no audio signal.
Note: The front panel power button is inoperative when the 12V Trigger or Audio Sense power
modes are selected.
10. 12V TRIGGER IN/OUT
Turns amplifier on when 12v dc is applied and power mode switch is set to 12v. This 12v
signal is regenerated to the 12v out for triggering additional amplifiers.
Note: the front panel power button is inoperative when the 12v trigger or audio sense power
modes are selected.
11. POWER CONNECTOR
12. FUSE LOCATION
EA-AMP-8D-70
1
2
3
4
5
6
7
8
9
10
11 12