AeroComm TRANSCEIVER ZB2430 - Manual (Page 61)

C O M P L I A N C Y I N F O R M A T I O N 5 6
Mobile - Mobile defines equipment where the user will be 20 cm or greater from the transmitting equipment. The
antenna must be mounted in such a way that it cannot be moved closer to the user with respect to the equipment,
although the equipment may be moved. (Note: Ankles, feet, wrists, and hands are permitted to be within 20 cm of
mobile equipment).
O E M E Q U I P M E N T L A B E L I N G R E Q U I R E M E N T S
WARNING: The OEM must ensure that FCC labeling requirements are met. This includes a clearly visible label on the
outside of the OEM enclosure specifying the appropriate AeroComm FCC identifier for this product as well as the FCC
notice below. The FCC identifiers are listed above.
Label and text information should be in a size of type large enough to be readiily legible, consistent with the
dimensions of the equipment and the label. However, the type size for the text is not required to be larger than eight
point.
A N T E N N A R E Q U I R E M E N T S
WARNING: This device has been tested with a U.FL connector with the above listed antennas. When integrated into
the OEM’s product, these fixed antennas require professional installation preventing end-users from replacing them
with non-approved antennas. Any antenna not listed in the above table must be tested to comply with FCC Section
15.203 for unique antenna connectors and Section 15.247 for emissions. Contact AeroComm for assistance.
Caution: Any changes or modifications not expressly approved by AeroComm could void the user’s authority to
operate the equipment.
W A R N I N G S R E Q U I R E D I N O E M M A N U A L S
WARNING: This equipment has been approved for mobile applications where the equipment should be used at
distances greater than 20 cm from the human body (with the exception of hands, feet, wrists, and ankles). Operation
at distances of less than 20 cm is strictly prohibited and requires additional SAR testing.
C H A N N E L W A R N I N G
The OEM must prevent the end-user from selecting a channel not approved for use by the FCC.
Contains FCC ID: KQL-ZB2430-100 / KQL-ZB2430D
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired
operation.