Steelcraft Automotive 51360 GRILL GUARD - Manual (Page 6)

GRILLE GUARD
2009-013 F-150
Page 6 of 7 1/31/13 Rev 5(DP)
Driver Side Installation Pictured
Fig 13
For easier installation, insert (1) 12mm Hex Bolt
per side in the location pictured in Figure 8 to act
as a hinge. Snug the hardware but do not tighten,
then rotate the Grille Guard up into position
Insert 12mm Plastic Washers between the Grille
Guard and the Mounting Bracket. Line up the holes in
the Plastic Washers with the mounting holes. Insert
the Mounting Bolts through the Plastic Washers
Fig 11
Insert a 3/8" Plastic Washer
between the Grille Guard and
the slotted Top Bracket. Line up
the hole in the Plastic Washer
with the mounting holes. Insert
the Quick Release Bolt through
the Plastic Washers
12mm x 35mm Hex Bolt
12mm Lock Washer
(2) 12mm Flat Washers
12mm Hex Nut
12mm Plastic Washer
Front
Front
Place a 3/8" Plastic Washer between
the slotted Top Bracket and the 3/8"
Flat Washer to protect the finish on
the Top Support Bracket
Fig 14A Front
Fig 12
(Fig 15) Cut area pictured for example only.
Installer responsible for correct modifications
Fig 14B