Steelcraft Automotive 53220 GRILL GUARD - Manual

Installation Instructions
GRILLE GUARD PART#
03-06 TOYOTA TUNDRA 2/4WD
Parts List
1 – front bar
2 – Top brackets
2 – Frame brackets
2 – 3/8 x 1 Button bolts
2 – 3/8 hex nuts
2 – 3/8 Flat Washers 6 – 7/16 x 1 ¼ Hex bolts
6 – 7/16 Hex Nuts 12 – 7/16 Flat Washers
Installing the top brackets
Open the vehicle hood to get to the existing hex nuts (located top left and top right). The
bolt pattern on the top brackets will be positioned in the manner shown in illustration
(passenger side shown). Attach top brackets using the existing factory hex nut.
Hand-tighten as you may have to move brackets around.
Installing the frame brackets
Remove factory tow hooks (but do not discard the factory bolts). The bolt pattern on the
frame mounting brackets will be positioned in manner shown in illustration (passenger
side shown). Attach frame brackets using the factory bolts. Installing the front bar
Line up the three holes on the lower portion of the front bar with the three holes on the
frame brackets (inner edge). Use the 7/16 x 1 ¼ hex bolts, 7/16 hex nuts and 7/16 flat
washers to fasten the front bar to the frame brackets. Top portion of the front bar will line
up with the hole on the top brackets (outer edge).Use the 3/8 x 1 button bolts, 3/8 hex
nuts and 3/8 flat washers to fasten the front bar. Once the front bar is attached to all
mounting brackets, align the left and right side of the front bar to the bumper and tighten
all fasteners.
NOTE: It is advisable to re-check all fasteners for tightness after one week.