Steelcraft Automotive 50170 GRILL GUARD User Manual
Parts list
INSTALLATION INSTRUCTIONS
GRILLE GUARD PART #
GMC SIERRA 2500/3500 HD 01-02
PARTS LIST
1-DRIVER SIDE MOUNTING BRACKETS 1-PASSENGER SIDE MOUNTING BRACKETS
2-M12×40 HEX BOLTS 10-M12 HEX NYLOCK NUTS 8-M12*30 HEX BOLTS
2-M10 HEX BOLTS 2- M10 HEX NYLOCK NUTS 2-M8 HEX BOLTS
2-M8 HEX NYLOCK NUTS 24-Φ12 FLAT WASHERS 8-Φ10 FLAT WASHERS
Product Installation
1.
BEFORE YOU START INSTALLATION , MAKE SURE THAT YOU HAVE ALL THE COMPONENTS LISTED ABOVE.
2.
REMOVE THE FRONT TOW HOOKS. NOTE: THE TOW HOOKS WILL NOT BE REINSTALLED ONCE THE FRONT BAR
IS MOUNTED.
3.
ONCE THE TOW HOOKS ARE REMOVED PROCEED TO INSTALL THE BRACKETS. USING FIGURE 1 TO IDENTIF
THE CORRECT BRACKET FOR EACH SIDE. THE BRACKETS FIT INSIDE EACH CHASSIS MEMBERS AS SHOWN IN
FIGURE 1. THE HOLES USED TO FASTEN THE LOW HOOKS TO THE CHASSIS MEMBERS WILL BE USED TO
FASTEN THE BRACKETS.
4.
INSERT THE BRACKET INSIDE THE CHASSIS MEMBERS AND ALIGN THE BRACKET HOLES WITH THE CHASSIS
MEMBER HOLES AND FASTEN (HAND-TIGHTEN ONLY) USING THE M12×40 BOLT AS SHOWN IN FIGURE 1.
5.
ONCE THE BRACKET ARE INSTALLED PROCEED TO MOUNT THE FRONT BAR ALIGN THE BRACKET MOUNTING
HOLES WITH THE FRONT BAR MOUNTING HOLES AND FASTEN (HAND-TIGHTEN ONLY), USING THE M12×40
BOLTS AS SHOWN IN FIGURE 1, MAKE SURE THAT BOTH MOUNTING BRAKCKETS STAY BETWEEN THE FRONT
BAR FEET.
6.
ALIGN THE FRONT BAR CAREFULLY AND BEGIN GRADUALLY TIGHTENING BOTH BRACKETS ALTERNATING
FROM ONE TO THE OTHER MAKING SURE THAT FROMT BAR STAYS CENTERED ON THE VEHICLE.
7.
FINALLY, ALIGN THE FRONT BAR VERTICALLY AND TIGHTEN THE REMATINING BOLTS.