Steelcraft Automotive 50060 GRILL GUARD - Manual (Page 2)

GRILLE GUARD
1999-02 NEW BODY STYLE GMC SIERRA 1500(LD)/00-06 YUKON 1500
EXCLUDES 1500HD AND DENALI MODELS
Page 2 of 3 2/20/12 Rev1 (DP)
10. Attach the Grille Guard to both Top Brackets using the included (2) 8mm x 30mm Hex Bolts, (4) 8mm
Small Flat Washers, (2) 8mm Lock Washers and (2) 8mm Hex Nuts, (Figure 6). Do not tighten
hardware at this time.
11. Level and adjust the Grille Guard and tighten all hardware.
12. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Grille Guard.
For gloss black finishes: Mild soap may be used to clean the Grille Guard.
Driver Side Installation Pictured
Remove (2) factory hex
bolts to remove tow hooks
Fig 1
Fig 2
Fig 3
(Fig 4) passenger side pictured
without grille in place
(2) 12mm x 40mm Hex Bolts
(4) 12mm Flat Washers
(2) 12mm Nylon Lock Nuts
Or use factory tow hook and
hardware
8mm x 30mm Hex Bolts
(2) 8mm Flat Washers
8mm Lock Washer
8mm Hex Nut
Remove factory bumper bracket bolt