Steelcraft Automotive 73290 BULL BAR - Manual (Page 3)

BULL BAR
2011 TOYOTA HIGHLANDER
Page 3 of 6 4/27/11 (DP)
There must be a minimum 15mm gap between the 12mm x 90mm Hex Bolt and the AC
compressor. (2) additional 12mm Flat Washers have been provided for use as a spacer.
Use a maximum of (3) Flat Washers under the head of the 12mm x 90mm Hex Bolt as
necessary, (Figures 12A & 12B). Snug but do not tighten hardware.
11. With assistance, position the Bull Bar up to the Mounting Brackets. Attach the Bull Bar to the
Mounting Brackets using the included (2) 12mm x 35mm Hex Bolts, (2) 12mm Lock Washers
and (2) 12mm Flat Washers, (Figure 13).
12. Level and adjust the Bull Bar properly and tighten all hardware at this time.
13. Completely secure the splash guard to the vehicle with the factory hardware.
14. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.
Gas Models: The vibration dampener is located
on the driver side of the front cross member
Hybrid Models: The vibration dampener is located
on the passenger side of the front cross member
Remove plastic plugs on top
and bottom of cross member
Fig 1 Fig 2
Fig 3
Front
Front
Front