Steelcraft Automotive 74030 BULL BAR User Manual
Page 2
6. Attach Bull Bar to Mounting Brackets using the included (2) ½” x 2” Hex Head Bolts, (2)
½” Lock Washers, (2) ½” Flat Washers. Do not tighten at this time.
7. Level and adjust Bull Bar properly; and then tighten all hardware at this time.
8. Do periodic inspections to the installation to make sure that all hardware is secure and
tight.
To protect your investment, wax this product after installing. Regular waxing is recommended
to add a protective layer over the finish. Do not use any type of polish or wax that may contain
abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the
finish. Mild soap may be used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.
(Driver Side Installation Shown)
Page 2 of 3
12/26/07 (AM)