Steelcraft Automotive 74150 BULL BAR - Manual

PARTS LIST:
1 Bull Bar 4 12-1.25mm Hex Head Bolts
1 Driver/Left Mounting Bracket 4 12-1.75mm Hex Head Bolts
1 Passenger/Right Mounting Bracket 4 12mm Hex Nuts
8 12mm Lock Washers
12 12mm ID x 29mm OD x 3mm Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2. From underside of vehicle, use a10mm socket wrench to remove the 6 bolts holding the center plastic
shroud. Set center plastic shroud on a clean working area and use a hack saw to cut out the driver side tow
hook cavity (Figure 1).
3. Remove the factory tow hook located on the passenger side (Figure 2). NOTE: You will not be re-installing
tow hook.
4. Once you have cut out the driver side tow hook cavity of shroud, reinstall it back to the vehicle using the
same factory hardware.
5. Locate the passenger side Mounting Bracket and partially hang it from factory threaded holes on the frame
rail using the included (2) 12-1.25 x 35mm Hex Head Bolts (fine thread), (2) 12mm Lock Washers, and (2)
12mm Flat Washers (Figure 3). Repeat this step for driver side.
6. With help position Bull Bar on the outer side of Mounting Brackets. Attach Bull Bar to Mounting Brackets
using the included (4) 12-1.75mm x 30mm Hex Head Bolts, (4) 12mm Lock Washers, (4) 12mm Hex Nuts,
and (8) 12mm Flat Washers (Figure 4).
7. Align Bull Bar properly and then tighten all hardware.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective
layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
Page 1 of 3 9/28/07
(AM)
INSTALLATION INSTRUCTIONS
3” BULL BAR
08-On NISSAN PATHFINDER
PART #
Driver Side
Mounting
Bracket
Passenger Side
Mounting
Bracket