Steelcraft Automotive 72320 BULL BAR - Manual

3” BULL BAR
2011 JEEP GRAND CHEROKEE
Page 1 of 3 12/17/10 (DP)
PARTS LIST:
1 Bull Bar
1 Driver/Left Side Frame Mounting Bracket
1 Passenger/Right Side Frame Mounting Bracket
8 10-1.5mm x 35mm Hex Bolts
12 10mm x 30mm OD x 2.5mm Flat Washers
8 10mm Lock Washers
4 10mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS
RECOMMENDED.
2. Determine if the vehicle is equipped with or without factory tow hooks, (Figure 1). Remove the
plastic splash guard, (Figure 2). Pay close attention to the type and location of all factory
hardware for easier reinstallation. If vehicle is equipped with tow hooks, remove both tow
hooks and skip ahead to Step 4. NOTE: Tow hooks cannot be reinstalled with the Bull Bar.
a. On vehicles without factory tow hooks: Release the clips at the ends of the plastic
bumper cover that attach the lower cover to the upper cover, (Figure 3). NOTE: It is not
necessary to remove the lower cover, only release the clips at the ends of the cover.
Next, remove the (3) clips fastening the air deflector to the bottom of the crossmember,
(Figure 4). Pull the bumper cover forward for access and pull the air deflector out from
behind the bumper cover, (Figure 5). Release the clips securing the (2) block off covers
to the ends of the air deflector, (Figure 6). Remove the (2) block offs. Reinstall the air
deflector using the factory hardware. Reinstall the bumper cover.
3. Select the driver side Frame Mounting Bracket. Line up the (2) slots in the bracket with the (2)
threaded holes in the bottom of the frame channel, (Figure 7). Bolt the Bracket to the frame
channel with (2) 10mm x 35mm Hex Bolts, (2) 10mm Flat Washers and (2) 10mm Lock
Washers, (Figure 8). Do not tighten hardware at this time. Repeat this step for passenger side
Frame Bracket installation.
4. With assistance, hold the Bull Bar up to the outside of the Mounting Brackets. Attach the Bull
Bar to the Mounting Brackets with the included (4) 10mm x 35mm Hex Bolts, (8) 10mm Flat
Washers, (4) 10mm Lock Washers and (4) 10mm Hex Nuts, (Figure 9).
IMPORTANT: This Bull Bar is not compatible with optional Adaptive Cruise Control-
Forward Collision Warning Systems featuring grille mounted laser control sensor.
Driver Side
Mounting Bracket
Passenger Side
Mounting Bracket
Complete Installation