Steelcraft Automotive 70230 BULL BAR - Manual (Page 2)

3" BULL BAR
2014 CHEVY SILVERADO1500/GMC SIERRA1500
Page 2 of 3 7/10/13 (DP)
6. Repeat Steps 4 & 5 to install the passenger side Mounting Bracket. If the bumper was removed, align
the bumper to the vehicle and tighten all factory hardware.
7. With assistance, position the Bull Bar up to the outside of the Mounting Brackets. Bolt the Bull Bar to
the Mounting Brackets using (4) 10mm x 30mm Hex Bolts, (8) 10mm Flat Washers, (4) 10mm Lock
Washers and (4) 10mm Hex Nuts, (Figure 6).
8. Align and adjust the Bull Bar and tighten all hardware.
9. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.
Driver Side Installation Pictured
(Fig 2) Dotted line on Silverado
bumper pictured for example only
(Fig 1) Sierra pictured for example only
(Fig 3) Driver side of Silverado pictured without
plastic cover for instructions purposes only
7-1/2"
10mm Bolt Plate 10mm Double Bolt Plate
2-1/2"
Cut out area illustrated for example only. Due to
different models and options, actual area
required for bracket clearance to be determined
by installer. Start with a small opening and
enlarge until proper clearance for best results.
Do not cut through
top edge of panel