Steelcraft Automotive 75090 SPORT BAR - Manual

PARTS LIST:
1 Sport Bar 4 12-1.75mm x 35mm Hex Head Bolt
1 Driver Mounting Bracket (A) 6 12mm Nylock Nuts
1 Passenger Mounting Bracket (B) 12 12mm ID x 30mm OD x 3mm
2 12-1.75mm x 60mm Hex Head Bolt Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.
2. Using a flat screwdriver carefully remove all fasteners from factory plastic shroud
underneath the vehicle. There are (4) on the front and (3) on each side by the fender
(Figure 1
3. Remove plastic shroud and place it on a working area. Using a hack saw; carefully cut the
driver side marked area shown in Figure 5.
4. Reposition factory plastic shroud with fasteners removed in step 2.
5. From underside of vehicle, locate and remove the passenger and driver factory sub frame
bolts located on the outer side of plastic shroud (Figure 2 & 3).
6. Position Passenger Side Mounting Bracket as shown in Figure 2 and secure it with factory
bolt removed in step 5. Do not tighten at this time.
7. Use the included (1) 12-1.75mm x 60mm Hex Head Bolt, (1) 12mm Nylock Nut, and (2)
12mm Flat Washers to attach the second mounting hole on the bracket to the existing
hole on the sub-frame of the vehicle (Figure 2). Do not tighten at this time.
8. Repeat steps 6-7 for driver side.
9. Mount Sport Bar on the inner side of Mounting Brackets (Figure 4). Use the included (4)
12-1.75mm x 35mm Hex Head Bolts, (4) 12mm Nylock Nuts, and (8) 12mm Flat Washers
to attach Sport Bar to both mounting brackets.
10. Once the Sport Bar is fully mounted on vehicle, level and adjust Sport Bar; then tighten all
hardware at this time.
11.Do periodic inspections to the installation to make sure that all hardware is secure and
tight.
Page 1 of 1
2/22/07 (AM )
INSTALLATION INSTRUCTIONS
SPORT BAR
2007 HONDA CRV
PART NUMBER 750905
Remove these fasteners
There are three more
fasteners by the fender
There are three more
fasteners by the fender
(A) (B)