Steelcraft Automotive 134200 RUNNING BOARD - Manual

VIEWPOINT RUNNING BOARDS
2011-12 TOYOTA SIENNA
Page 1 of 6 9/20/12 (DP)
PARTS LIST:
1 Driver/Left side Running Board 2 10mm x 50
mm “T” Bolts
1 Passenger/Right side Running Board 6 10mm Bent Threaded Rod Bolts
1 Driver/Left front Mounting Bracket 8 10mm Plastic Retainers
1 Passenger/Right front Mounting Bracket 2 10-1.5mm x 25mm Hex Bolts
1 Driver/Left front Support Bracket 10 10mm x 27mm x 3mm STD Flat Washers
1 Passenger/right front Support Bracket 4 10mm x 34mm x 3mm Large Flat Washers
1 Driver/left center Mounting Bracket 12 10mm Serrated Flange Nuts
1 Passenger/right center Mounting Bracket 12 6mm T-Bolts
1 Driver/Left rear Mounting Bracket 12 6mm x 22mm OD x 2mm Flat Washers
1 Passenger/right rear Mounting Bracket 12 6mm Lock Washers
2 10mm x 35mm button head Bolt Plates 12 6mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED. ASSISTANCE IS
RECOMMENDED.
2. Start installation under the driver side front of the vehicle. Remove the plastic cover, (Fig. 1). Pay close
attention to the type and location of all factory hardware for reinstallation.
3. Locate the (2) factory holes in the inside wall of the floor panel, (Fig. 2). NOTE: The mounting locations
may be covered by sealant or undercoating. Use a small screwdriver to poke through the sealant to
uncover the hole. IMPORTANT: Brackets must sit flat against sheet metal. Scrape any excess sealant
from body panel before installing any and all Brackets.
Driver/Left Rear
Mounting Bracket
Driver/Left Front
Mounting Bracket
Driver/Left
Center Bracket
Passenger/Right
Rear Mounting
Bracket
Passenger/Right
Center Bracket
Passenger/Right Front
Mounting Bracket
(2) 10mm x 50mm T-Bolts
(For Rear Brackets only)
(6) 10mm Rod Bolts
(2) 10mm x 35mm
Button Head Bolt Plates
Driver/Left
Running Board
Passenger/Right
Running Board
Front
Driver/Left Front
Support Bracket Passenger/Right Front
Support Bracket