Steelcraft Automotive 133150 RUNNING BOARD - Manual

VIEWPOINT RUNNING BOARDS
2010-12 LEXUS RX350
Page 1 of 8 10/23/12 (DP)
PARTS LIST:
1 Driver Side Running Board 4 10mm Plastic Retainer
1 Passenger Side Running Board 2 10mm x 50mm “T” Bolts (Rear Bracket only)
1 Driver Side Front Mounting Bracket 2 10mm x 35mm Button Head Bolt Plates
1 Passenger Side Front Mounting Bracket 4 10mm x 25mm Hex Bolts
1 Driver Side Center Mounting Bracket 2 10mm x 34mm x 3mm Large Flat Washers
1 Passenger Side Center Mounting Bracket 6 10mm x 27mm x 3mm STD Flat Washers
1 Driver Side Rear Mounting Bracket 4 10mm Lock Washers
1 Passenger Side Rear Mounting Bracket 4 10-1.5mm Serrated Flange Nuts Gr 8.8
1 10mm Insert Installing Tool 12
6mm x 20 mm “T” Bolts (Running Board)
1 6mm Insert Installing Tool 4 6-1.0mm x 25mm Hex Head Bolts
4 10-1.5mm Threaded Inserts 16 6mm x 22mm OD x 2mm Flat Washers
3 6-1.0mm Threaded Inserts 16 6mm Lock Washers
12 6mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED. DRILLING IS
REQUIRED. ASSISTANCE IS RECOMMENDED.
2. Start installation under the driver side front of the vehicle. Remove the plastic covers, (Fig. 1). Pay
close attention to the type and location of all factory hardware for reinstallation.
3. Locate the (2) factory holes in the inside wall of the floor panel, (Fig. 1). NOTE: The mounting locations
may be covered by rubber plugs, sealant and/or undercoating. IMPORTANT: Scrape any excess
sealant from body panel before installing any and all Brackets.
4. Select (1) 10mm Threaded Insert, (1) 10mm Insert Tool, (1) 10mm x 25mm Hex Bolt and (1) 10mm x
27mm STD Flat Washer. Assemble the Threaded Insert as pictured in Figure 2. Insert the Threaded
Insert assembly into the forward, larger hole in the inner body panel, (Fig. 4). NOTE: If Insert fits too
tight, enlarge hole by drilling with a 1/2" drill bit. IMPORTANT: Be careful not to enlarge hole too much.
Insert should fit snug in hole and lip on Insert should be against sheet metal surface.
Driver/Left Rear
Mounting Bracket
Driver/Left Front
Mounting Bracket
Driver/Left
Center Bracket
Passenger/Right
Rear Mounting
Bracket
Passenger/Right
Center Bracket
Passenger/Right Front
Mounting Bracket
(2) 10mm x 50mm T-Bolts
(For Rear Brackets only)
(2) 10mm x 35mm Bolt Plates
10mm Threaded Insert Tool
Driver/Left
Running Board
Passenger/Right
Running Board
Front
6mm Threaded
Insert Tool