Steelcraft Automotive 170700 RUNNING BOARD - Manual (Page 5)

ALUMINUM VIEWPOINT RUNNING BOARDS
2013 HYUNDAI SANTA FE
Page 5 of 8 4/15/13(DP)
Driver Side Installation Pictured
Front
(Fig 6) Hold the driver side center bracket up
and over the threaded hole. Mark the outline
of the Bracket onto the plastic cover.
Remove the plastic cover.
Front
(Fig 4) Driver side front Bracket pictured
Remove the factory hex bolt
securing the end of the plastic
cover to the floor panel
(Fig 5) Driver side center Bracket location pictured
Front
Remove all factory
clips along body panel
10mm Flat Washer
10mm Lock Washer
10mm Hex Nut
(Fig 7) Bolt the driver side center bracket
in place. Mark the slot onto the pinch
weld. Remove the Bracket and drill a 1/4"
hole through the pinch weld
Factory 6mm
hex bolt