Steelcraft Automotive 121120 RUNNING BOARD - Manual (Page 2)

VIEWPOINT ALUMINUM RUNNING BOARD
2011-13 DODGE DURANGO
Page 2 of 3 9/5/12 (DP)
Flat Washers, (6) 6mm Lock Washers and (6) 6mm Hex Nuts, (Figure 9). Do not tighten hardware at
this time.
6. Adjust and level the Running Board and tighten all hardware.
7. Repeat Steps 1
– 6 for passenger/right Running Board installation.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Running Board.
For gloss black finishes: Mild soap may be used to clean the Running Board.
Driver Side Installation Pictured
(Fig 1) Driver side front mounting location pictured
Fig 3 Fig 4
Remove rubber plugs
Rear
Front
(1) 12mm x 40mm Bolt Plate
(1) 12mm Plastic Retainer
(1) 12mm x 24mm Flat Washer
(1) 12mm Flange Nut
(Fig 2) Driver side rear mounting location pictured
Mounting holes
in pinch weld