Steelcraft Automotive 113900 RUNNING BOARD - Manual (Page 6)

VIEWPOINT ALUMINUM RUNNING BOARDS
2011-12 FORD EXPLORER
Page 6 of 7 10/10/12 (DP)
Driver Side Installation Pictured
Front
8mm Threaded Insert
8mm x 25mm Hex Bolt
8mm Lock Washer
8mm x 22mm Flat Washer
Fig 15
Fig 13
Front
(Fig 14) Properly
installed Insert
Fig 16
Rear
8mm Threaded Insert
8mm Hex Bolt
8mm Flat Washer
(Fig 12) Mark Support Bracket location onto
pinch weld. Carefully drill the location with 7/16"
drill bit. Do not drill and install the Insert until
after the Sidebar has been completely installed,
checked for level and aligned on the vehicle.
Repeat procedure to install all Inserts.
Mark Support Bracket location onto pinch weld.
Carefully drill the location with 7/16" drill bit