Steelcraft Automotive 213100 3 ROUND SIDE BAR - Manual (Page 2)

3" SIDE BAR
03-11 FORD EXPEDITION (EXCLUDES "EL")
Page 2 of 3 9/1/11 REV1(DP)
5. Select the passenger Sidebar and carefully place it up to the Brackets. Bolt the Side Bar to the
Mounting Brackets with the included (2) 1/2
” x 2” Hex Bolts, (2) 1/2” Lock Washers and (2) 1/2” Flat
Washers (Figures 5 & 6). Do not tighten hardware at this time.
6. Level and adjust the Side Bar and tighten all hardware at this time.
7. Repeat Steps 2 - 6 for driver Side Bar installation.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Passenger Side Installation Pictured
Fig 1
(Fig 2) Passenger side front
mounting location pictured
Fig 3
Remove clip nuts
if equipped
(2) 8mm Self Tapping Hex Bolts
(2) 8mm x 25mm Hex Bolts
(4) 8mm Flat Washers
(2) 8mm Nylon Lock Nuts
Front
Front