Steelcraft Automotive 233800 3 ROUND SIDE BAR - Manual

SIDEBAR
2010 - 12 TOYOTA 4RUNNER "SR5" AND "LIMITED" MODELS
WITH ROCKER PANEL EXTENSIONS
EXCLUDES "TRAIL EDITION"
Page 1 of 2 4/3/12 (DP)
PARTS LIST:
Qty Description Qty Description
1 Driver/Left Sidebar 24 8-1.25mm x 30mm Hex Bolts
1 Passenger/Right Sidebar 24 8mm Lock Washers
2 Front Mounting Brackets 24 8mm x 22mm OD x 2mm Flat Washers
4 Center & Rear Mounting Brackets
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY. ASSISTANCE IS RECOMMENDED.
2. Starting on the driver side front of the vehicle, remove the (2) factory hex bolts securing the
lower rocker panel bracket to the bottom of the body, (Figure 1). NOTE: Only install (1)
bracket at a time. Select (1) Front Mounting Bracket. Hold the Sidebar Bracket in place over
the factory rocker panel bracket. Bolt the Mounting Bracket to the vehicle using the included
(2) 8mm x 30mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figure 2).
Do not tighten hardware at this time.
3. Repeat Step 2 for Center and Rear Bracket installation, (Figures 3 & 4).
4. With assistance, carefully place the Driver/Left Sidebar onto the (3) Brackets. WARNING: Do
not rotate the Sidebar on the cradle or the finish on the Sidebar may be damaged. Align the
threaded holes in the bottom of the Sidebar with the holes on the Mounting Brackets. Attach
the Sidebar to the Mounting Brackets with the included (6) 8mm x 30mm Hex Bolts, (6) 8mm
Lock Washers and (6) 8mm Flat Washers, (Figure 5). Do not tighten at this time.
5. Level and adjust the Sidebar properly and tighten all hardware.
6. Repeat Steps 2 - 5 for passenger Sidebar installation.
7. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
(4) Center and Rear Mounting Brackets
(2) Front Mounting Brackets