Steelcraft Automotive 240920 3 ROUND SIDE BAR User Manual
Page 2
PROCEDURE:
1.
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2.
There are two threaded holes and a slotted hole on the frame towards the front of the vehicle. Use
the two threaded holes to partially install the driver front Frame Bracket to frame using the
included (2) 10mm x 30mm Hex Head Bolts, (2) 10mm Lock Washers, and (2) 10mm Flat
Washers (Figure 1 & 2). NOTE: If vehicle is equipped with factory sidebars, you may use the
factory bolts.
3.
Proceed to attach the driver front Sidebar Bracket to the side facing the rear of the vehicle of the
already installed Frame Bracket. Use the included (2) 12mm x 35mm Hex Head Bolts, (2) 12mm
Nylock Nuts, and (4) 12m Flat Washers (Figure 3). NOTE: The cradle on the Sidebar Bracket
should be facing the rear of the vehicle. Do not tighten at this time.
4.
There are two threaded holes and three non-threaded holes on the frame towards the rear of the
vehicle. Use the two threaded holes to partially install the driver rear Frame Bracket to frame using
the included (2) 10mm x 30mm Hex Head Bolts, (2) 10mm Lock Washers, and (2) 10mm Flat
Washers (Figure 4 & 5). NOTE: If vehicle is equipped with factory sidebars, you may use the
factory bolts.
5.
Attach the driver rear Sidebar Bracket to the side facing the front of the vehicle of the already
installed Frame Bracket. Use the included (2) 12mm x 35mm Hex Head Bolts, (2) 12mm Nylock
Nuts, and (4) 12m Flat Washers (Figure 6). NOTE: The cradle on the Sidebar Bracket should be
facing the rear of the vehicle. Do not tighten at this time.
6.
Position Sidebar onto Mounting Brackets. Attach Sidebar to Mounting Brackets using the included
(4) 8mm x 25mm Hex Head Bolts, (4) 8mm Lock Washers, and (4) 8mm Flat Washers (Figure 7).
Do not tighten at this time.
7. Adjust Sidebar properly; and then tighten all hardware at this time.
8. Repeat steps 2-7 for passenger Sidebar.
9. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
(Driver Front Mounting Brackets Shown)
Page 2 of 4
8/24/07
(AM)
Factory threaded
holes
10mm x 30mm Hex Bolts
10mm Lock Washers
10mm Flat Washers
Or
Factory Bolts
Front of
Vehicle
Front of
Vehicle
Front of
Vehicle
Fig 1
Fig 2