Steelcraft Automotive 403800 4 OVAL SIDE BAR - Manual

4" STRAIGHT OVAL SIDEBAR
07-11 CHEVY TRAVERSE/GMC ACADIA/07-10 SATURN OUTLOOK/07-09 BUICK ENCLAVE
(EXCL. 2010-11 BUICK ENCLAVE)
Page 1 of 5 3/24/11Rev1(DP)
PARTS LIST:
1 Driver/Left Sidebar 6 12mm Lock Washers
1 Passenger/Right Sidebar 6 12mm ID x 32mm OD x 3mm Flat Washers
1 Driver/Left Front Mounting Bracket 6 12mm Hex Nuts
1 Passenger/Right Front Mounting Bracket 4 10mm Lock Washers
1 Driver/Left Rear Mounting Bracket 4 10mm x 27mm OD x 3mm Flat Washers
1 Passenger/Right Rear Mounting Bracket 4 10mm Hex Nuts
2 “Z” Brackets W/Welded 8mm Hex Nuts 12 8-1.25mm x 25mm Hex Bolts
6 12-1.75mm x 45mm Bolt Plates 12 8mm Lock Washers
4 10-1.5mm x 35mm Button Head Bolt Plates 10 8mm ID x 24mm OD x 2mm Flat Washers
6 12mm Square Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2. Start installation on the passenger side and locate the factory holes in the bottom and side of the floor
panel towards the front of the vehicle.
a. On 2007-09 Vehicles: There is an oval hole and a round hole on the bottom of the floor panel
and a round hole on the side of the floor panel. Insert (1) 12mm x 45mm Bolt Plate into the oval
hole and turn the Bolt Plate 90-degees so that the plate is across opening, (Figures 1 & 3B).
b. On 2010-11 Vehicles: There are two round holes on the bottom of the floor panel, (one
centered, one offset toward the pinch weld), and one round hole on the side of the floor panel.
Insert (1) 10mm x 35mm Button Head Bolt Plate into the round hole in the center of the floor
panel (Figures 2 & 4B). Make sure that the plate is supported across the hole in the floor panel.
3. Next, select (1) 8mm "Z" Bracket, (Figure 1B). Insert the end with the hex nut welded onto the outside
of the Bracket into the round hole in the bottom of the floor panel. Maneuver the "Z" Bracket through the
inside of the floor panel and line it up to the hole in the side of the floor panel, (Figures 1A, 2 & 6).
Driver/Left Side
Front Mounting
Bracket
Driver/Left
Side Rear
Mounting
Bracket
Passenger/Right Side
Front Mounting
Bracket
Passenger/Right
Side Rear
Mounting
Bracket
(6) 12mm x 35mm
Bolt Plates
(6) 12mm Square Washers
(4) 10mm Button Head Bolt
Plates (Use for installation on
2010-11 Vehicles Only)
Passenger/Right Sidebar
Driver/Left Sidebar
Front
(2) "Z" Brackets
W/8mm Hex Nuts