Steelcraft Automotive 412410p 4 PREMIUM OVAL SIDE BAR - Manual

4" OVAL BENT END SIDEBARS
04-08 F-150 SUPER CAB
Page 1 of 3 6/2/11 Rev2(DP)
PARTS LIST:
Qty Description Qty Description
1 Driver/Left Sidebar 2 12mm x 45mm Double Bolt Plates
1 Passenger/Right Sidebar 4 12mm Plastic Retainers
1 Driver/Left Front Mounting Bracket 6 12mm x 32mm OD x 3mm Flat Washers
1 Passenger/Right Front Mounting Bracket 6 12mm Lock Washers
1 Driver/Left Rear Mounting Bracket 6 12mm Hex Nuts
1 Passenger/Right Rear Mounting Bracket 4 8mm Clip Nuts
4 1/2” x 2” Hex Bolts 8 8-1.25mm x 30mm Hex Bolts
4 1/2” x 1-1/2” x 1/8” Flat Washers 12 8mm x 24mm OD x 2mm Flat Washers
4 1/2” Lock Washers 8 8mm Lock Washers
2 12mm x 40mm Single Bolt Plates 4 8mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting at the passenger side-front of the vehicle, locate the round and rectangular openings in the
inner body panel. NOTE: Mounting holes may be covered with rubber plugs and/or sealing tape.
Remove to uncover mounting locations. Insert (2) 8mm Clip Nuts, (with the nut portion to the inside),
into the rectangular opening and line up the threaded nut with the factory round holes, (Figure 1). Next,
partially thread (1) 12mm Plastic Retainer onto (1) 12mm Bolt Plate, (Figure 2), and insert the Bolt
Plate into the large round hole. Once inserted, thread the Plastic Retainer onto the threaded end of the
Bolt Plate until it is flush against the body panel. NOTE: When properly installed, the Plastic Retainer is
designed to prevent the Bolt Plate from falling into the body cavity during Bracket installation.
3. Locate the driver side front Mounting Bracket. Attach the Mounting Bracket to the Bolt Plate with (1)
12mm Flat Washer, (1) 12mm Lock Washer and (1) 12mm Hex Nut, (Figure 3). Do not tighten
hardware at this time. Line up the two holes in the Mounting Bracket with the previously installed Nut
Clips and secure with (2) 8mm Hex Bolts, (2) 8mm Flat Washers and (2) 8mm Lock Washers. Do not
tighten hardware at this time. Next, line up the two holes in the bottom of the Mounting Bracket with the
factory holes in the pinch weld. Attach the Mounting Bracket to the pinch weld using the included (2)
8mm x 30mm Hex Bolts, (2) 8mm Lock Washers, (4) 8mm Flat Washers and (2) 8mm Hex Nuts,
Driver/Left Front
Mounting Bracket
Driver/Left Rear
Mounting Bracket
Passenger/Right
Front Mounting
Bracket
Passenger/Right
Rear Mounting
Bracket
(2) 12mm Single Bolt
Plates (For front use only)
(2) 12mm Double Bolt Plates
(For rear use only)
(4) 12mm Plastic Retainers
Passenger/Right Sidebar
Driver/Left Sidebar
Front (NOTE: front step pads
slightly back from end of tube)
(NOTE: rear step pads are
closer to end of tube)