Steelcraft Automotive 402229 5 OVAL SIDE BAR - Manual

5” OVAL STRAIGHT SIDE BAR
99-11 1500-2500-3500 SILVERADO/SIERRA CREW CAB
1500 SUBURBAN
Page 1 of 5 10/6/10 Rev1(DP)
PARTS LIST:
1 Driver/Left Side Bar 4 12mm x 32mm x 3mm Flat Washers
1 Passenger/Right Side Bar 2 12mm Lock Washers
1 Driver/Left Front Mounting Bracket 2 12mm Hex Nuts
1 Passenger/Right Front Mounting Bracket 2 10mm Nut Plates
1 Driver/Left Side Center Mounting Bracket 6 10-1.50mm x 30mm Hex Bolts
1
Passenger/Right Side Center Mounting
Bracket
10 10mm x 20mm OD x 2mm Flat Washers
1 Driver/Left Rear Mounting Bracket 6 10mm Lock Washers
1 Passenger/Right Rear Mounting Bracket 4 10mm Hex Nuts
1 Driver/Left Front Support Bracket 12 8-1.25mm x 25mm Hex Bolts
1 Passenger/Right Front Support Bracket 12 8mm ID x 24mm OD x 2mm Flat Washers
2 Center Support Brackets 12 8mm Lock Washers
2 12-1.75mm x 30mm Hex Bolts
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
1. Start the installation under the driver side of the vehicle and remove the front, center and rear body
mount bolts. Do not remove bushings.
2. Hang the driver side front, center and rear Mounting Brackets from the body mounts using the factory
hex bolts, (Figure 1). Do not tighten hardware at this time.
3. Locate the two factory holes in the bottom of the frame towards the front of the vehicle. Insert (1) 10mm
Nut Plate into the oval hole and line up the threaded nut with the forward round hole, (Figure 2).
4. Attach the driver side front Support Bracket to the Nut Plate with (1) 10mm x 30mm Hex Bolt, (1) 10mm
Lock Washer and (1) 10mm Flat Washer, (Figure 3 & 4). Do not tighten hardware at this time.
Passenger Side
Center
Mounting
Bracket
Passenger
Side Rear
Mounting
Bracket
Passenger Side Front
Mounting Bracket
Driver Side
Rear
Mounting
Bracket
Driver Side
Center
Mounting
Bracket
Driver Side Front
Mounting Bracket
Driver Side Front
Support Bracket
Passenger Side
Front Support Bracket
Center
Support
Bracket
(2) 10mm Nut Plates
Center
Support
Bracket
Front of Sidebar-inserts slightly closer to end of tube Rear
Note: Use location of threaded inserts in bottom of tube to identify front of Sidebar