Steelcraft Automotive 413809 5 OVAL SIDE BAR - Manual (Page 2)

5IN STRAIGHT OVAL SIDEBAR
09-11 FORD F-150 SUPER CREW CAB
Page 2 of 3 8/16/10 (DP)
6). Do not tighten hardware at this time. NOTE: The cradle on the Center Mounting Bracket
should face the front of the vehicle.
7. Carefully position the Sidebar onto the Mounting Bracket cradles and attach it using the
included (6) 8mm x 25mm Hex Bolts, (6) 8mm Lock Washers and (6) 8mm Flat Washers,
(Figure 4). Do not tighten hardware at this time.
8. Level and adjust the Sidebar properly and tighten all hardware.
9. Repeat steps 2
– 8 for passenger Sidebar installation.
10. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Driver Side Installation Pictured
(Fig 1) 10mm Clip Nuts (hole in body panel shown for
example only-location and shape may differ slightly)
(2) 8mm x 25mm Hex Bolts
(2) 8mm Lock Washer
(4) 8mm Flat Washers
(2) 8mm Hex Nuts
Fig 3
(Fig 2) Driver side-front Mounting Bracket location
Front
(2) 10mm Clip Nuts
(2) 10mm x 30mm Hex Bolts
(2) 10mm Lock Washers
(2) 10mm Flat Washers
(2) 10mm Clip Nuts
(2) 10mm x 30mm Hex Bolts
(2) 10mm Lock Washers
(2) 10mm Flat Washers
Front
(2) 8mm x 25mm Hex Bolts
(2) 8mm Lock Washer
(4) 8mm Flat Washers
(2) 8mm Hex Nuts