Steelcraft Automotive 33250 TAILLIGHT GUARD - Manual (Page 2)

TAILLIGHT GUARD
2005-13 TOYOTA TACOMA
Page 2 of 3 Rev 1 (DP) 8/28/13
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Taillight Guard.
For gloss black finishes: Mild soap may be used to clean the Taillight Guard.
Driver Side Installation Pictured
Fig 1
(Fig 2) Firmly grasp taillight assembly
at top and bottom and pull straight out
from vehicle (toward rear)
(Fig 3) Slide the Taillight Guard over the
taillight assembly from the top down
(Fig 4A) Hook the small tab onto the
outer edge of the taillight assembly
Remove (2) factory hex bolts
to remove taillight assembly