Steelcraft Automotive 33210 TAILLIGHT GUARD - Manual

PARTS LIST:
1 Passenger Side Taillight Guard 4 #14 x 1” Sheet Metal Screws
1 Driver Side Taillight Guard
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.
2. Open rear door. Grasp the taillight housing with one hand and pull gently. WARNING: Be sure
to pull straight out to avoid possible damage. If is too tight, then use a large standard flat screw
driver and something like a cardboard backing of a note pad or towel to protect the paint from
damage. Gently pry off the outside of the taillight assembly out of the vehicle. This is the same
procedure required to change a burn out taillight in the assembly.
3. Carefully attach Taillight Guard onto taillight housing by sliding down Taillight Guard from the
top of the taillight housing. The two support brackets should hook to the edge of the taillight
housing. If they don’t fit correctly, they can be adjusted to fit correctly using a pair of pliers.
4. Return the assembly back to the vehicle making sure that the Taillight Guard is aligned and
centered correctly on the taillight housing.
5. Close rear door and make sure that the Taillight Guard does not interfere.
6. Once the Taillight Guard is aligned, use the holes on the bracket as a template to mark the
drilling location on the taillight housing (Figure 2).
7. Use the included (2) #14 x 1” Sheet Metal Screws to secure the Taillight Guard.
IMPORTANT: Do not over tighten or a pull out can occur.
8. Repeat steps 2-7 for opposite side.
IMPORTANT: Do periodic inspections to the installation to make sure that all hardware is secure
and tight.
Page 1 of 1 1/11/07 (AM)
INSTALLATION INSTRUCTIONS
TAILLIGHT GUARD
03-07 TOYOTA 4RUNNER
PART NUMBER 33210 / 33217
Support
Brackets
Drilling
Location
Figure 1
Figure 2