Steelcraft Automotive 32130 TAILLIGHT GUARD - Manual

STEELCRAFT
INSTALLATION INSTRUCTIONS
TAILLIGHT GUARD PART # 32130
2005-2007 JEEEP GRAND CHEROKEE
PARTS LIST
(1)- TAILLIGHT GUARD PASSENGER SIDE
(1)- TAILLIGHT GUARD DRIVER SIDE
(2)- SUPPORT BRACKETS
(2)- # 6 x 1/2" SCREWS, (4)- #10 x 1” SCREWS, (4)- #10 FLAT WASHERS (2)- # 8 x 1/2"
INSTALLING TAILLIGHT GUARD
1) START WITH THE DRIVER SIDE, OPEN THE REAR LIFT GATE AND REMOVE THE SCREWS SECURING THE
TAIL LIGHT TO THE BODY.
2) CAREFULLY UNSNAP THE TAIL LIGHT UNTIL IT IS FREED FROM THE HOUSING.
3) ATTACH SUPPORT BRACKET TO THE EDGE OF VEHICLE USING THE # 8 x 1/2” SELF TAPPING SCREWS
(MARK AND DRILL HOLE USING A # 7 DRILL BIT) POSITION SUPPORT BRACKET AS SHOWN.
4) SNAP THE TAIL LIGHT ASSEMBLY BACK INTO BODY.
5) POSITION REAR TAILLIGHT GUARD OVER TAIL LIGHT, MAKING SURE THAT THE MOUNTING BRACKETS
ON THE TAILLIGHT GUARD ARE SEATED WHERE THE TAIL LIGHT SCREWS WERE FORMERLY LOCATED.
6) SECURE ASSEMBLY TO JAMB USING THE # 10 x 1” SCREWS AND # 10 FLAT WASHERS. SUPPORT BRACKET
USE THE # 6 x 1/2” SCREWS.
7) RE-PEAT STEPS 1 THROUGH 6 ON THE OPPOSITE SIDE.
CUSTOMER SERVICE TOLL FREE (888) 261-4537