Steelcraft Automotive 31030 TAILLIGHT GUARD - Manual

INSTALLATION INSTRUCTION
TAIL LIGHT GUARD FOR
00-06 Excursion
NOTE: Please read this information before installing. NO DRILLING REQUIRED for installation of these
tail light guards. To obtain correct installation, we recommend you follow these step by step installation
instructions carefully. Please take care when installing this product to protect the finish and your investment.
Step One: Locate hardware and check contents with the hardware listed below.
QTY
DESCRIPTION
1 Taillight Guard ( Passenger & Driver)
6 ST4.2 x 60 Sheet Metal Screws
6 M5 Flat Washers
Step Two: Remove the two bottom and inside top mounting screws that support the tail light to the vehicle as
shown in figure #1.
Step Three: Position and center tail light guard onto the vehicle. NOTE: During shipping Brackets may loose
their shape. In order to get a proper fit, Bracket might need to be re-shaped slightly by bending them until sitting
flush with taillight housing.
Step Four: Secure the guard to the vehicle using the included Sheet Metal Screws as shown in figure # 2. Repeat
steps two and four for opposite side.
Figure 1 Figure 2
Cleaning Instructions: For stainless steel, an aluminum polish may be used to polish small scratches and scuffs on
the finish. Mild soap, window and glass cleaner may be used to clean stainless steel. For gloss black finishes: Mild
soap, window and glass cleaner may be used. Do not use any type of polish or wax that contains abrasive that could
damage the finish.
Taillight
Mounting
Locations